Yes, you can connect two fiber optic cables to a single switch, either for redundancy or link aggregation, provided the ports, modules, and fiber types are compatible.

Basic Setup

To connect two fiber optic cables to a single switch, you need to ensure the following:

• SFP Modules: Each fiber cable must terminate in a compatible SFP (Small Form-factor Pluggable) module installed in the switch port. For example, Cisco GLC-SX-MM modules are commonly used for multimode fiber connections .
• Fiber Type: Ensure both cables are either single-mode or multimode, matching the SFP module specifications .
• Connectors: LC-LC duplex connectors are standard for most switch-to-switch fiber connections .
• Port Configuration: The switch ports should be enabled and configured for the correct speed and duplex mode.

Use Cases

1. Redundancy: Connecting two fibers to separate ports on the same switch can provide a backup path. If one link fails, the other maintains connectivity .
2. Link Aggregation (LACP): Two fibers can be combined into a single logical link to increase bandwidth. This requires configuring EtherChannel or port-channel on the switch .

Practical Considerations

• Distance and Power Budget: Ensure the fiber length does not exceed the maximum supported distance for the SFP modules and that optical power levels are within the acceptable range .
• Wavelength Matching: For single-fiber or dual-fiber modules, the transmit and receive wavelengths must match between the two switches .
• Topology: In larger networks, switches can be cascaded in star, tree, or bus topologies. Connecting multiple fibers to a single switch can help manage traffic efficiently and reduce congestion .
• Testing: Always test each fiber link individually before aggregating or using them for redundancy to ensure proper connectivity and protocol status (up/up) on the switch ports .

By following these guidelines, connecting two fiber optic cables to a single switch can enhance network reliability, bandwidth, and scalability while maintaining proper signal integrity and compatibility.