You connect an indoor fiber optic cable to a router by first linking it to an Optical Network Terminal (ONT), then connecting the ONT to your router via Ethernet.

Step 1: Gather Necessary Equipment

• Optical Network Terminal (ONT): Provided by your ISP, it converts optical signals into electrical signals your router can use .
• Fiber optic cable: Usually a thin yellow cable with SC/APC or SC/UPC connectors .
• Router: Ensure it has a WAN port or supports fiber input via SFP/PON modules .
• Ethernet cable: To connect the ONT to the router .

Step 2: Connect Fiber Cable to the ONT

1. Locate the fiber wall outlet where the ISP's fiber enters your home .
2. Remove protective caps from both the fiber cable and the ONT port.
3. Align the connector key or tab and insert the fiber cable into the ONT's optical port until it clicks securely .
4. Power on the ONT and wait 2–5 minutes for the status lights to stabilize, indicating a successful connection .

Step 3: Connect the ONT to Your Router

1. Use an Ethernet cable to connect the ONT's LAN/Ethernet port to the router's WAN port .
2. Power on the router and wait for the indicator lights to confirm connectivity .

Step 4: Configure and Test

• Access your router's configuration interface via a web browser (commonly 192.168.0.1 or 192.168.1.1) if manual setup is required .
• Verify that the router receives an internet signal and that Wi-Fi or wired connections are functioning.

Tips and Precautions

• Handle fiber cables carefully: Avoid touching the glass tip to prevent damage or signal loss .
• Placement: Keep the ONT and router in a dry, ventilated area near power outlets .
• Surge protection: Use a surge suppressor to protect your devices.
• Check compatibility: Some routers require SFP modules or media converters for direct fiber input . By following these steps, your indoor fiber optic cable will be properly connected to your router, ensuring high-speed, low-latency internet throughout your home.